Donaldson Torit CPV-1 Specifications download pdf (Page 19)

Torit PowerCore, CPV-1 to CPV-12

Side-Mount Power Pack

Electrical service or maintenance

work must be performed by

a qualiﬁed electrician and comply with all

applicable national and local codes.

Turn power off and lock out electrical

power sources before performing service or

maintenance work.

Do not install in classiﬁed hazardous

atmospheres without an enclosure rated for

the application.

Mounting a power pack on the

side of a collector requires a

power pack adapter to support the weight of

the power pack.

Poorly installed power packs may separate

from the collector resulting in personal injury

and damage to equipment or property.

1. Disconnect power supply.

2. Apply 1/4-in diameter rope-type sealant to the

outside surface of the power pack adapter between

the fan mount bolt holes and the round fan inlet hole.

3. Install the fan housing to the power pack adapter

using 3/8 x 1 1/4-in bolts, ﬂat washers, and hex nuts.

Install bolts with the bolt head in

the fan housing and the threaded

end in the power pack adapter.

4. Reinstall the motor, bracket, and fan wheel assembly.

Align motor mount bracket to the mark on the

housing on 30 Hp/60 Hz and 20-30 Hp/50 Hz units.

Other motor sizes do not require alignment, but

consider the electrical connection location.

5. Connect power supply to the motor. Turn the fan

motor ON then OFF to check motor rotation by

referencing the rotation arrow on the blower.

To change rotation on three

phase units, turn power supply

OFF and switch any two leads on the output

side of the fan motor starter.

NOTICE

Do not look into fan outlet to

determine rotation. View the fan

rotation from the back of the motor.

Check that the exhaust plenum is free of tools

or debris before checking blower/fan rotation.

Stand clear of exhaust to avoid personal injury.

To reverse rotation, three-phase power supply: Turn

electrical power OFF at source and switch any two

leads on the output-side of the fan motor starter.

Do not interchange a power lead

with the ground wire. Severe

personal injury or equipment damage may

result.

power pack adapter

CPV-2, -3, or -4 Side Mount Power Pack

power pack adapter

CPV-6, -8, or -12 Side Mount Power Pack

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Comments to this Manuals

No comments

Donaldson Torit CPV-1 Specifications Page 19

Comments to this Manuals

Related products and manuals for Dust covers Donaldson Torit CPV-1