Donaldson Torit DFO 3-6 Specifications download pdf (Page 35)

Downflo II Dust Collector

Abrasion-Resistant Inlet Collar

collector

sealant

3/8-in

flat washer

3/8-16 x 1-in

bolt

abrasion

resistant

inlet collar

bottom

cover

Abrasion-Resistant Inlet Collar

1. Remove the unit’s front cover plate. Remove

excess sealant from opening.

2. Apply 1/4-in diameter rope-type sealant around

the opening toward the inside edge of the bolt

pattern.

3. Align the holes on the inlet collar with the holes

in the unit and secure using 3/8-16 x 1-in bolts

and flat washers supplied.

Note: Elbows attached directly to the abrasion-

resistant inlet should be long sweep

elbows. Place the centerline of the elbow

perpendicular to the front of the collector.

Top-Mount Plenum Silencer

and Damper Installation

Plenum Silencer, TRB

Top Mount

1. Apply sealant and attach the bottom panel to

the collector as described on the assembly

drawing shipped with the silencer. Use a

combination of hardware removed from the

unit and hardware supplied.

2. Install the fan and motor assembly as described

in the Power Pack on Page 16 and the assembly

drawing.

3. Route rigid or flexible conduit from the junction

box on the motor to the outside wall of the

silencer to house wiring.

4. Install the top of the silencer and attach the

silencer to the base using the supplied

hardware.

5. Loosen the wing nut on the damper and adjust

to approximately 50% closed.

silencer

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 51 52

Comments to this Manuals

No comments

Donaldson Torit DFO 3-6 Specifications Page 35

Comments to this Manuals

Related products and manuals for Dust covers Donaldson Torit DFO 3-6