Donaldson Torit TBV-2 Specifications download pdf (Page 18)

Donaldson Company, Inc.

Preliminary Start-Up Check

1. Check all electrical connections for tightness and

contact.

2. Check for and remove all loose items in or near

the inlet and outlet of the unit.

3. Check that all remote controls are wired into the

control system and all service switches are in the

OFF position.

4. Check that all optional accessories are installed

properly and secured.

5. Check that hopper discharge is open and the

storage container is sealed, if equipped.

6. Turn power ON at source.

7. Turn the compressed-air supply ON. Adjust

pressure regulator for 90-psi.

8. Turn the fan motor ON then OFF to check

for proper rotation by referencing the rotation

arrow located on the motor’s mounting plate.

Do not look into fan outlet to

determine rotation. View the

fan rotation through the back of the motor.

Check that the exhaust plenum is free of

tools or debris before checking blower/fan

rotation.

Stand clear of exhaust to avoid personal

injury.

To reverse rotation, single-phase power supply:

Follow manufacturer’s instructions on the

motor’s nameplate.

To reverse rotation, three-phase power supply:

Turn electrical power OFF at source and switch

any two leads on the output-side of the fan-

motor starter.

9. Adjust the blower/fan for proper airflow by

adjusting the volume control damper on the

blower/fan discharge, if equipped.

Excess airflow can shorten

filter life, cause electrical

system failure, and blower motor failure.

NOTICE

Start-Up

1. Turn compressed-air supply ON. Adjust

regulator to 90-psi.

2. Turn blower fan motor ON.

3. Adjust airflow using the airflow control damper,

if equipped.

Service Information

Turn power off / lock out

electrical power sources before

performing service or maintenance work.

Turn compressed air supply OFF and

bleed lines before performing service or

maintenance work.

Operational Checklist

1. Monitor overall performance of the collector.

2. Monitor exhaust.

3. Monitor pressure drop across filters.

4. Monitor dust disposal.

Filter Element Removal

Place filter part-number

label (supplied with each

replacement filter) over the filter part

number listed on the unit’s rating plate.

1. After compressed air supply and electrical power

have been turned off, open the roof access door

of the TBV unit to its fully open position. Make

sure that the small notch on the roof support

slide bar drops down and locks into position,

securing the roof access panel.

Failure to open the door

properly could result in

personal injury. Ensure the door is in the

correct open position.

2. Reach inside the clean air plenum of the unit

and disconnect the blowpipes by pulling back

the levers of the quick-disconnect pipe couplers.

Stow the blowpipes in the upright position by

inserting them into the slots provided at the rear

of the unit.

3. Reach down inside the clean air plenum of the

unit and halfway unscrew all the black hold-

NOTICE

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Comments to this Manuals

No comments

Donaldson Torit TBV-2 Specifications Page 18

Comments to this Manuals