Donaldson Torit TBV-2 Specifications download pdf (Page 20)

Donaldson Company, Inc.

Filter Element Installation

See the Filter Installation

for TBV for first time filter

installation for insertable models.

1. Place the new filter element end-cap down

(gasket-side up). Slide the filter hold-down collar

insidetheopenofthefilterelementuntilitstops.

2. Slide the steel grounding tab through the filter

crank rod, followed by the rubber-backed

washer, rubber side up and away from the crank

handle.

3. Slide the filter crank rod through the hole in the

filter element end cap and up through the filter

cartridge. Align the filter crank rod end with the

quick-nut assembly located in the center of the

hold-down collar bracket and screw together

until the filter cartridge forms an air-tight seal

against the filter hold-down collar.

4. Insert the complete filter/venturi assembly back

into the clean air plenum until the hold-down

collar is flush with bottom of the clean air

plenum (tubesheet). Rotate the assembly to the

left (counterclockwise) until all four (4) screw

studs are engaged.

5. Tighten all black hold-down knobs until secure.

Reconnect the blowpipes using the quick release

pipe couplers.

6. Grasp the roof access door with one hand and

pull up on the bottom of the roof support slide

bar with the other to disengage the locked

position. Lower the roof access door until closed

and secure by twisting the T-handle latches on

the top of the roof.

NOTICE

venturi

1/4-in nut

1/4-in flat

washer

collar bracket

1/4-in bolt

rubber-back

washer

filter crank

rod

quick nut

assembly

filter

hold-down

collar

filter

element

steel

grounding

tab

Filter / Venturi Assembly

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Comments to this Manuals

No comments

Donaldson Torit TBV-2 Specifications Page 20

Comments to this Manuals